- Business Name : self
- Address :
- Telephone No. :
- Fax No. :
- Website :
- Email :
- Opening Hours :
- Rating : 90 Out Of 340
Latest Customers To Use This Business
Comments
acstestinc -> Makes following the speed limit easier (nudge, nudge, wink ,wink) here in Canada. Odometer was adjusted to correct KM's.
70styleVega -> Transferred stock rear axle brackets to Ford 8 inch axle, relocated upper mounting points 1.75 inch, later added brackets to relocate upper mounting points to 3.00 inch (found sketches on H-body.org showing old school no-hop bars with 3.150 relocation)
acstestinc -> Replaced catalytic with custom made bolt in straight pipe.
Real nice change to exhaust tone even with stock muffler.
75Monza5.7 -> Body work completed and new Basecoat/Clearcoat paint job. Factory original color using PPG Deltron paint. Painted in my garage. $600.00 of paint and untold number of hours of blood, sweat, and tears.
littlevega56 -> paint , GM code72 .. hugger orange
littlevega56 -> painted body
littlevega56 -> paint picture
littlevega56 -> paint picture
skizer -> got car sealed and primered, ready for block sanding
skizer -> Got parts painted today
skizer -> paint
76-cosworth-z09 -> Kenwood Exceleron deck
SOHCracer -> Freshened up engine for 2009
SOHCracer -> Trans built by well known Buick GNX racer Vince Janis.
sportster96blk -> updated photo
crtaylor7 -> Body Side ground effects. 10 ga. aluminum 4.5" X .5" broke. Raps into wheel wells.
rocketride -> Budget built 355 cid
TRW flat tops w/ stock crank and rods
Lunati VooDoo cam and lifters
.468 /.489 Duration 262° /268° RPM Range 1400-5800
882 heads w/ mild port job and after market springs (bought this way)
Weiand stealth intake w/ Carter AFB 625
Stock HEI w/ Accel Super Coil and module
Corvette aluminum water pump w/ Monza pulleys
mini starter
Hooker 2135 headers
dress up kit
I'm hoping for around 300 HP.
pyarbro -> Installing the new S-10 Master cylinder in my ryde. Had to file away some of the master cylinder opening on the fire wall to fit the s-10 parts. using the Vega pushrod to reach pedal correctly. and purchasing a new proportioning valve
