Torque boxing?

Anything H-body related, but please use one of the topic-specific forums below if appropriate

Moderator: Moderators

Torque boxing?

Postby Greybeard » Tue Oct 10, 2017 12:57 pm

I've recently pulled the roll cage out of my Vega. I'm 6'3" and the Halo bar was 2" from my temple, which I didn't care much for, and to be truly NHRA approved I would need a door bar to boot. The car also had been sub framed, but the sub frame stops at the tranny crossmember.
Ive been thinking about adding flat plate from the crossmember forward to the firewall, welding it to the floor to create a sort of torque boxing.
Has anyone done this before? Am I just wasting time and energy? Also, while I'm at it, has anyone done firewall to fender bracing like is found in some of the more modern performance cars?
Thanks
Mike
1937 Chev 2dr sedan
1966 Chevy El Camino (daily driver w/300K miles)
1966 Chevy V8 Corvair https://greybeard.shutterfly.com
1972 Vega GT
1985 Corvette
1999 Safari Sahara 30' with Cat 330
1999 Jeep Cherokee 'toad'
Next: 1964 289 slabside Cobra, LS525 power
User avatar
Greybeard
 
Posts: 79
Joined: Mon Dec 08, 2014 4:48 am
Location: Sequim, Washington


Re: Torque boxing?

Postby Smiley » Thu Oct 26, 2017 3:21 pm

Can you post some pictures of where your frame rails end ?

The H-body floor is multi layered in the crossmember area, depending on how they attached the rails it should be ok.

Did you remove the whole roll cage or just the halo bar ?
User avatar
Smiley
 
Posts: 683
Joined: Tue Jul 17, 2012 2:50 am


Return to General Discussion

Who is online

Users browsing this forum: Google Adsense [Bot] and 3 guests