The Official H-Body Internet Community

I think it turned out all right.. Opinions/suggestions welcomed

Like what you have done. I am going to do the split bumper on my 73 also. Like what you did on the end with the fiberglass. I have though about how to dress up the ends after the cut was made. How are you going to finish the fiberglass tips? Be sure to show a finished pictiue. Keep up the good work.

Although it looks good, I see an issue. Fiberglass and metal expand and contract at different rates, and therefore the paint will crack. Or do you plan to just paint the endcap?

Will be using a Imron Polyurethane Enamel paint on the bumpers. Had great luck with it in the past.. very crack and chip resistant.
I also but up quite a few layers of glass on the back side, and its rock solid, so imo there shouldn't be any issues. Thanks for the
replies.

No paint, just primed.. looks pretty factory to me I think

Picture dosn't to it justice...

I hope you didn't cut up a nice straight bumper to make these. I have several damaged bumpers that I would have gladly cut up and welded like this for you in trade for a one good straight 71-72 bumper.

Ken

Nope. The bumper wasn't all that great. Dings, scratches, needed a rechrome.