by 79440bird » Tue Nov 18, 2014 4:08 am
These are made from injected urethane. I have only made a few of these caps, then ran out of material an started working on the filler panel. These caps do not have the metal inside the handle where the screws hold the metal part on. I have that area filled with urethane an the screws hold good. The Chevy cap was something else I was playing around with. Not sure if it's the correct angles on it but thought it would be kool. It's all urethane and only sticks out about the same if not less than the OEM grab handle 1/2" or 3/8
Last edited by
79440bird on Thu Mar 14, 2024 3:05 am, edited 2 times in total.
79 sunbird 440 chrysler motor indy cyl heads12bolt leaf springs 80 sunbird 3800supercharged everything from a 99 bonneville 75 cosworth 350 dual quads 84 efi vette intake mod for carbs 78 Buick skyhawk 350 buick motor A/C &TA performance intake