removing glovebox liner

Anything H-body related, but please use one of the topic-specific forums below if appropriate

Moderator: Moderators

removing glovebox liner

Postby chevyart » Sat Apr 01, 2017 4:12 pm

there is no heater blower on my 75 vega. just a steel panel there to close hole. i want to put my small igniition box and coil on the panel but i dont just want to use sheet metal screws to hold box and coil to thin cover. i want to use nuts and bolts going through and need to get under that area to thighten the nuts. is it an easy job to remove the glove box liner.? im pretty sure i will be behind that liner when i install the box and coil. thanks art
chevyart
 
Posts: 1839
Joined: Fri Oct 27, 2006 10:00 pm


Re: removing glovebox liner

Postby rpoz-29 » Sat Apr 01, 2017 9:39 pm

I'm pretty sure the only screws are around the front opening of the glove box. The glove box door and the box come out in one piece, IIRC.
rpoz-29
 
Posts: 1225
Joined: Sat Nov 04, 2006 11:39 am

Re: removing glovebox liner

Postby chevyart » Sun Apr 02, 2017 11:59 am

thanks rp, gonna go at it today. Art
chevyart
 
Posts: 1839
Joined: Fri Oct 27, 2006 10:00 pm

Re: removing glovebox liner

Postby KZVEGA » Sun Apr 02, 2017 7:37 pm

If it's similar to my 72 you shouldn't need to remove the liner it's all open and below the glove box. I did the same thing. Trans dip stick, ignition coil and oil pressure sending unit are all mounted on my block off plate for the blower assembly.
KZVEGA
 
Posts: 139
Joined: Mon Aug 12, 2013 7:04 pm
Location: Chicago, IL

Re: removing glovebox liner

Postby chevyart » Mon Apr 03, 2017 12:58 pm

thanks KZ: that simplifies it even more. thought i was going yesterday to do this. bu didnt make it. going todaywith the thought that it will even be easier to mount my parts properly. Art
chevyart
 
Posts: 1839
Joined: Fri Oct 27, 2006 10:00 pm


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest