I am replacing my u-joints, and the factory slip yoke (transmission end of driveshaft) has some wear from the trans bushing (which is also getting replaced). Problem is, know one seams to make the yoke any more, at least that I could find. 75 Monza 2+2, factory 262 (now 350) v-8, 4-spd (Sag switched to M-21) 27 spline. Anyone know of a slip yoke to use for a replacement?
Perry
The Official H-Body Internet Community
Vega, Monza, Sunbird, Astre, Starfire, Skyhawk
Driveline Slip Yoke
Moderator: Moderators
5 posts
• Page 1 of 1
Driveline Slip Yoke
by monzapla » Wed Jun 19, 2019 1:18 pm
-
monzapla - Posts: 157
- Joined: Wed Jun 28, 2006 3:39 pm
- Location: Tri-Cities, WA.
1975 Chevrolet Monza 2+2
Re: Driveline Slip Yoke
by monzapla » Thu Jun 20, 2019 4:43 pm
I think I found it.
SPICER 2-3-4911X Drive Shaft Transmission Slip Yoke, seems to match the right specification.
Summit is the only place that stocks it, that I have found so far.
SPICER 2-3-4911X Drive Shaft Transmission Slip Yoke, seems to match the right specification.
Summit is the only place that stocks it, that I have found so far.
-
monzapla - Posts: 157
- Joined: Wed Jun 28, 2006 3:39 pm
- Location: Tri-Cities, WA.
1975 Chevrolet Monza 2+2
Re: Driveline Slip Yoke
by Monza Harry » Thu Jun 20, 2019 5:02 pm
Did you try Monzaz?
I'm not a hoarder I'm a preservationist 78 Monza Spyder (~Soon(ish +/- I guess) To Be 2+2 with Spoilers)
-
Monza Harry - Posts: 2568
- Joined: Tue Oct 04, 2011 8:50 am
- Location: Windsor ON Canada
1978 Chevrolet Monza 2+2
Re: Driveline Slip Yoke
by monzapla » Fri Jun 21, 2019 11:41 am
Monza Harry wrote:Did you try Monzaz?
Who? What?
-
monzapla - Posts: 157
- Joined: Wed Jun 28, 2006 3:39 pm
- Location: Tri-Cities, WA.
1975 Chevrolet Monza 2+2
Re: Driveline Slip Yoke
by dindin » Fri Jun 21, 2019 1:11 pm
He is a member here his website is http://jdrace.com..
- dindin
- Posts: 550
- Joined: Wed May 21, 2014 10:01 am
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests