I am planning on running the torque arm set up on my 80' spyder but was wanting to know how I can stiffen the back f the car to get as much bite as i can.
The rear end is going to be a toyota rear end (similar design to a ford 9").
IM not planning on running a tire wider than 10".
IM already planning frame ties and an 8 point cage.
I was thinking of running a B&M torue arm mount on the back of the tranny but I understand this is hard on the tranny.
Is there a better way of mounting it?
Can the torque arm be boxed for strength?
How strong is the back of these chassis'?
God bless
-Shred