My torque arm
Posted: Sun Jun 03, 2007 8:36 pm
Here is pics of my freshly made torque arm.I'll try to explain as best i can.
I put a 200-4r in the car over winter,to make that fit i took a Hooker style crossmember and lengthened it,2 pieces of 1 1/2 and and a piece if 1 1/2 square tubing.
I run a chrsler 8 3/4 rear,in wich i welded tabs to the top and bottom of the housing.
I then built my torque arm out of 1 1/4 mild steel tubing with 3 3/4 inch heim joints and an ladder link.To be able to set pinion angle.
The front bracket will weld to the tranny crossmember.
I'll add more pics when it's in the car tuesday.
[/img]http://www.knights-rule.com/cgi/gallery/d/5347-2/100_0711.jpg
I put a 200-4r in the car over winter,to make that fit i took a Hooker style crossmember and lengthened it,2 pieces of 1 1/2 and and a piece if 1 1/2 square tubing.
I run a chrsler 8 3/4 rear,in wich i welded tabs to the top and bottom of the housing.
I then built my torque arm out of 1 1/4 mild steel tubing with 3 3/4 inch heim joints and an ladder link.To be able to set pinion angle.
The front bracket will weld to the tranny crossmember.
I'll add more pics when it's in the car tuesday.
[/img]http://www.knights-rule.com/cgi/gallery/d/5347-2/100_0711.jpg