by crawfw » Tue Dec 16, 2014 8:52 pm
You're welcome. I'm surprised no one else chimed in. It's always good to get several opinions/experiences.
Anyhow my springs were 13.25"to 13.5"before cutting them.
I cut them to 12.5" which may be a little low for my liking. I was hoping to be able to get my floor jack under the k member.
The ride height and handling are fine though.
Thought I had it on the money until I drove it a few times.
Then it settled and dropped close to where it was with the drop spindles maybe a smidge lower.
I had new springs on standby but haven't wanted to mess with it again.