The Official H-Body Internet Community

Anyone out there have the torque specs for an 82 S10 2wd front disc brake caliper bolts and bajo bolts from an S10 manual? I am 99% done with the conversion

I just did mine, found all sort sorts of varying torque specs on google, not sure if any were actual GM manual specs. I ended up doing about 35 lbs for the pins and although a few sites said to do 32 lb for the banjo-- I chickened out at 20-- felt good and tight and I wasn't about to have to drill out out a busted one!

here's a link I used: http://torquespecs.tripod.com/s-1xabrakes.htm

The information on Mitchell ProDemand for the '82 S-10 says 35 lb/ft for the caliper bolt.


Chuck

Thanks, I did 32 on banjos and 37 on caliper pins.