Anybody running "big bore" metric calipers?
Posted: Thu Jun 16, 2016 11:17 pm
I've been studying up on my upcoming s10 brake conversion. It's consist of monza lower A arms rebuilt with sleeve adapters and AJE uppers. Gotta go pull early s10 spindles etc. BUT... I've seen a lot of guys have trouble nailing down the master cylinder
My thoughts have brought me too running these calipers
https://www.ebay.com/itm/381527473459 with stock s10 rotors. I also have new 67 camaro drum brakes out back. During my digging I found this article helpful
http://www.hotrodders.com/forum/manual- ... tml#/enter
FINALLY I believe I'm gonna use a 1" master from like a 78 camaro manual brakes I think this should work real well anybody have any experience with those calipers or similar setup?!?
Thank you Alvin
My thoughts have brought me too running these calipers
https://www.ebay.com/itm/381527473459 with stock s10 rotors. I also have new 67 camaro drum brakes out back. During my digging I found this article helpful
http://www.hotrodders.com/forum/manual- ... tml#/enter
FINALLY I believe I'm gonna use a 1" master from like a 78 camaro manual brakes I think this should work real well anybody have any experience with those calipers or similar setup?!?
Thank you Alvin