Finally got the springs installed, when looking for torque setting I found sheet show that flat side is down, I have some pictures of everything..I ending buying a rather expensive tool for this one, just felt very uneasy about the whole job and wanted to be safe, I did have to file the shock hole some to get the rod through, went pretty good once I got going, I place the jack under the control are as I eas compressing the spring, once the spring got high enough I gave the jack a couple pumps and the spring slide perfectly into the pocket..I then connected the knuckle .
Here are some pictures I took
front coil vega instructions.6.jpg
coil tool 2.5.png
coil install tool .5.jpg
in arms 3.5.jpg
You do not have the required permissions to view the files attached to this post.