cjbiagi wrote:Never heard of any other bar that would fit our chassis. There were some factory 1 1/8" front bars so probably need to scavenge the bone yards or internet. There were also some 1 1/16" bars that would be my second choice.....measure carefully as they are very close to each other.
There is also a 1" bar so don't trust the "Eyeball Caliper" I am a toolmaker and they are very hard to judge by eye [or a tape measure] even for someone that does that sort of thing daily, just to confirm what Clyde says! This cost me over $200 [Canadian dollars, that is what I get paid in
]to find out I already had a 1 1/8" bar [now been sold off] just to have an Addco,
and a 1 1/16" [holding onto for fine tuning as required as well as 2 different diameter rear bars, and again they look incredibly the same so use a proper measuring device] Just to add to the confusion do you have the LCA's with the sway bar mounts? If you do not that does offer some options for fab'ing one to fit.
I think one off of a "S" truck may be doable with some creativity and they are available in a few other sizes to offer some adjustability/tunability. Harry
I'm not a hoarder I'm a preservationist 78 Monza Spyder (~Soon(ish +/- I guess) To Be 2+2 with Spoilers)