I have compared the relaxed height, load capacities, compressed height, wire diameters of several of the H-bodys from 74 thru 78 and am having a tough time determining which is the correct spring for my particular set up. Smiley?..Harry?
The set up is deep pocket 75 lower control arms, V6 4.3, with air cond. I believe I ordered shocks for the V8 77 Monza, which shouldn't make a difference in the overall heigh (is this a correct assumption?). Theres a good 5 inches between the top of the tire and the bottom of the wheel well and I would like to lower it without cutting springs or heating them till they sag into place. I hear thats a bad way to go.
The two Moog numbers I looked at were -6490 and 5576. I am not sure which ones I ordered and installed.
I see that just because you need to lower 4 inches doesn't mean that you cut 4 inches off of a relaxed coil spring. S-10 spindles and axles and 15 inch wheels are on it now. Thanks in advance..Peace