Weber Carb setup

Moderator: Moderators

Weber Carb setup

Postby EagleFish » Sat Jul 01, 2006 6:37 pm

Well, it just arrived today and it is setting on my living room floor. I bought a brand new Weber carburetor setup from Hutton Motor Engineering (HME) complete with intake, linkage, air cleaner and installation parts. In other words, a bolt-on kit. This will complete my Cosworth Vega restoration project. I am eliminating the EFI system in favor of the carb setup. It is so sweet! >D
These carbs are almost all gone as their manufacture is discontinued. HME had to get the carbs out of Spain. The whole setup cost with shipping to my house was $1325.00. It will be a while until I get the setup installed and running. But, I can hardly wait!

I completed some work on my 79 Spyder. The 305 engine smoked, used a lot oil and didn't perform all that well. I removed the valve covers and found a lot of sludge built up preventing the oil from draining back to the crankcase quickly. I rodded out all of the drain back holes pulling most of the sludge back out, changed the oil and filter. Now it doesn't smoke or blow out oil. It idles smoothly, even with the a/c on and it runs much better over all.

I am very hbody happy!

Richard (John and Richard)
Posts: 1937
Joined: Wed Jun 28, 2006 5:44 pm
Location: Clearwater & Dade City, FL

1978 Buick Skyhawk

Postby marco_1978_spyder » Mon Jul 03, 2006 7:22 pm

Must be nice....get anything installed yet?

Glad to hear ol Richard is still tinkering with the H's.

I never sent any pictures of my formula sunbird to him..
just not sure if I really want to sell it I guess.

Its tucked away in dry storage right now.
1978 Monza Spyder V8 4speed, posi
1978 Sunbird Formula V6, 5 Speed, Hatchback
1980 Sunbird Hatchback 4cyl, 4spd.
2006 Chevrolet Aveo 5 speed Hatchback
Yes, you can refer to me as Mark
Please visit my blog... Follow if you like!
Featuring special guests; Carl Beraytor and Ray D'atore

My Red spyder now has a youtube channel please Like and Subscribe!!! ... ISuing7KLA
User avatar
Senior Moderator
Posts: 5275
Joined: Sun Jun 25, 2006 5:20 pm
Location: Western, New YorK / Rochester

Return to Carb/Intake/EFI Induction Tech

Who is online

Users browsing this forum: No registered users and 1 guest