Here's some pix of that intake I bought from Aus:
Here's a pic of the intake with the Q-jet sitting on top. BTW that is the Q-jet I got off ebay. It's going to need the flange to be bushed. The throttle shafts are sloppy enough to wiggle around so I figure it's time. I'm looking forward to modifying it:
The floor of the intake is pretty rounded. It's hard to get a good shot of that but I hope this isn't too different from what Shred was expecting. We'll see. This is also a nice close up of the flange modification for the Q-jet spread-bore. This is particularly hard to find for my engine. They just don't make them. The bottom pic is of the flange and the underside of the Q-jet. COOL!
OH one more thing to show is the custom intake heater. It's made from a hard line taped into the rear coolant ports and covered wiht braided line for show. I'm not sure this will work well but we'll see: