I also found some thing like that at Lowes stores maybe Marco could find them they were marked as a front door weather strip sticking up on a end of a aslile I looked at Home Depot and could not find them,,,
It has a long area where the pop rivets could be used and hid when you raise the ovelaping edge up and slip the top of the Mirage panel into the crease.
You could put two sided tape and fit it and put two or four rivets into the bottom and pull the tape waxed part out of the top and press the panel into the new painted body then remove the bottom rivets and Mirage panel and drill new holes if you could not get the old hole's to alighn up,,
Method two place tape on the old hole's and make a crosshair to find the old holes and hope you get it right,I have done a lot of custom vans with body panel's and flare,, spoiler's replacement at the body shop. the new tracks would be a plus as the old one are brittle and no replacement stock has ever been found.
One of the member's on the Older Monza Site V8monza.com.,,,,was all up for making a run of extrusions.,,,,
He was a CAD engineer,,,and could draw up a die to cast the units but needed a person in a manufacturig extruder plant to get permission for a run of say 250 units each five to six foot long.,,,Some cars would need a few extra pieces,,, The cost?????
Each Mirage owner at least some $$$$$bucks
Unless we had a "h-body member" with "conection's" and could "swing the deal",,,,, So where is
FordTruckNut
Has he changed his name????? Mike