Hi, does anyone have a solution to torn and warped FRP panels including the nose, tail and those outboard rubber bumperettes with captive studs that rust out and bulge? Im concerned about spending time refinishing my original rubber pieces if they are just going to warp and spiderweb in a few years. Im also concerned about using fiberglass pieces since the nose was originally meant to fit over the fiberglass reinforcement and I'll obviously have to toss this if going to a fiberglass piece. Won't it be especially weak where it flops down to fill the gap between the front bumper and fender, if it can't flex?
Also having read-up about showcars-bodyparts Im curious whom among you have had good luck with fiberglass parts vendors in terms of customer service and fit problems. I live in Canada so customer service will be a big factor in deciding which vendor i go with. Thanks.