The Official H-Body Internet Community

I wanted to remove a Monza outer weatherstrip on the door but couldn't get to a couple of the screws. The window will not roll down far enough. I couldn't remove the bottom travel stop because it's welded to the door. How do you remove the outer weatherstrip on these cars? Anybody have a factory shop manual? How does it say to remove the weatherstrip?

If you miss a day on here you have some catching up to do! Here is a link to previous thread with some good Idea's Harry viewtopic.php?f=1&t=43892&p=260693#p260693

Monza Harry wrote:If you miss a day on here you have some catching up to do! Here is a link to previous thread with some good Idea's Harry viewtopic.php?f=1&t=43892&p=260693#p260693

Thanks for the link. I'm surprised nobody mentioned removing the bottom stop by drilling out the spot welds. Then reinstall with bolts or pop rivets. Similar to replacing a window regulator. I noticed they also are spot welded. I still wonder what procedure is shown in a factory shop manual. Do you have a shop manual?

Monza Harry wrote:If you miss a day on here you have some catching up to do! Here is a link to previous thread with some good Idea's Harry viewtopic.php?f=1&t=43892&p=260693#p260693

I was able to remove the screws with a short Phillips head bit. Like Clyde suggested in the link you provided. First I removed the front window channel (held by three bolts) which allowed me to scoot the window forward and out of the rear channel. Then I was able to push the window inboard enough to use the Phillips bit. I used a piece of tape to protect the window and pressed the window against the bit while turning with a wrench.

Ask and ye shall receive! Glad we could help out! Nice idea with the tape and then using the glass to hold that falling little B d in place Every time we post some of these on going threads somebody adds a little more. and it gets just a little easier! Harry