edit:
OH joy, more surprises popped up:
Click here!!
I'm so sad and pissed off...
it appeared that they used plain normal 4" rings on it too, not the 4.060" ones...
I feel like strangling the guy who sold me this block.
/edit
Most likely if my block's cilinders turn out to be too wide for the pistons I will be buying a set of flat top pistons.
thing is I already need new rings which are pretty expensive locally as a set of 8 stock 350ci piston rings costing $125, and then the required bore and sleeve job which could be around $50 per cilinder...
So from summitracing I want to order these.
basically Hypereutectic aluminum 4.030 sized, including rings.
Will this screw up my factory rebuilt balance of the crank or engine at a whole?
would I need new rod-to-piston connectors?
any other stuff I missed if I'm ordering just this set of pistons with rings?
I want to run a pretty high but good & clean compression and no oilburning smoke.