Monza Harry wrote:Ken that would be a nightmare to remove in my opinion, I believe that is part of the roof skin. I added some links up above Kevin. Harry
Kenova wrote:How much work is involved with pulling the top of the cowl off as Harry suggested?
If it wasn't in the way you would probably find it a lot easier to do the repair.
cjbiagi wrote:Nice work! If you are going to run the clutch cable you may want to look at a thread where I posted some pics of a firewall/clutch cable brace I made for my car. While I never had any serious firewall issues I did realize that there was a small amount of flex and wanted to do something to eliminate it. The brace transfers a lot of the stress from the cable away from the firewall and to a much stronger part of the chassis. It's a good tip for anyone with a manual trans/clutch cables setup.
cjbiagi wrote:The idea of bracing the dash from the inside is good but the problem is that the firewall area is double walled with a slight gap between the panels if I remember correctly. So, bracing the interior panel does not help the outer piece of the firewall from flexing from the cable stress. Adding the brace in the engine compartment side directly transfers the energy from the cable to the much stronger part of the chassis on the wheelwell.
Users browsing this forum: No registered users and 1 guest