Motor mounts are burned into place.
Was able to reuse the factory frame plates so I had to shorten the shackle mounts, rubber bushings pressed in/out very easy.
engine3.jpeg
Pic of the RH mount:
rh mount.jpeg
Pic of LH mount:
LH mount.jpeg
Have only 3.5" of clearance to radiator for air inlet to the throttle body.
This is where a '99-02 3800 with drive by wire would give several more inches of clearance.
TB.jpeg
Still have a little clean up on the welds and brackets before paint.
Next off to the trans mount so the power train can sit on its own while I make some exhaust manifolds.
You do not have the required permissions to view the files attached to this post.