From:
twincams_REMOVE_500731_THIS_@yahoo.com
--- In <a href="/group/cosworthvegas/post?protectID=219233066105193209050199029077192253163098100009128121188190230091025019053061151110147">cosworthvegas@yahoogroups.com</a>, "Mark A. Rock <<a href="/group/cosworthvegas/post?protectID=029166091163127190025067203043129208071">markrock@c...</a>>"
<<a href="/group/cosworthvegas/post?protectID=029166091163127190025067203043129208071">markrock@c...</a>> wrote:
> Does anyone have the following specs for the BD3 camshafts?:
Mark
Since the Cams were a custom design by Bill Hutton you will have to
ask him Crane WILL NOT give out the information because it is a
Propritory Grind (owned by Hutton).
From memory the last was .007" - .008" intake, .009" - .010"
exhaust, gross lift was .340" (yes it's a lower lift than the stock
cams) and I can't remember the duration.
Later
Tim
[This is message #10275 by user twincams on Yahoo! Group Cosworth Vegas:
http://groups.yahoo.com/group/cosworthvegas ]