Moderator: Moderators
DEMON Precision wrote:3x3 ???? that,s huge , id use 1 1/2" x.120" wall DOM
Hatchback72 wrote:DEMON Precision wrote:3x3 ???? that,s huge , id use 1 1/2" x.120" wall DOM
Oops
2x3 tubing dropped crossmember, and 3x3 tubing for the rear lower control arm mounts, just looking for any measurements from anyone that aready made it
DEMON Precision wrote:Hatchback72 wrote:DEMON Precision wrote:3x3 ???? that,s huge , id use 1 1/2" x.120" wall DOM
Oops
2x3 tubing dropped crossmember, and 3x3 tubing for the rear lower control arm mounts, just looking for any measurements from anyone that aready made it
for the lowers i,d be inclined to use a round ladderbar crossmember upside down , and for the uppers i,d use some mounts built off the crossmember , if you stay with the 4link set-up , or i,d be inclined to swap the 4 link for a torquearm , then you only need the two lower mounts and a crossmember up front to mount the torquearm .
Users browsing this forum: No registered users and 8 guests