Like the topic says i need alittle help, I'm about to start my frame rails and i need to know where i should support the car while cutting out for the rails, normally this wouldn't be a issue but with the amount of rust my car has i'm a bit concerned about where i should support the car, Lets put it this way when i jacked the car up to do the front suspension i put the jack stands under the front support pockets and the jack stand on the right side went right through it.
I'm going to be running my rails right up against the rockers as they will also be taking the place of the rear control arm mounts so i won't have the rear in the car to use that as support.
I was wondering if i put stands under the front front k-member, where the control arms mount and also putting a set under the rear bumper, would this work? as i only plan on cutting and installing 1 side at a time, then tie'ing them in at the rear and at the trans mount.