Don Hardy V-8 MOUNTS explained

[h-bot]

From: vega_man_larry_REMOVE_140613_THIS_@yahoo.com


I have 2 sets only. Body side - the mounts attach
to the stock vega motor mount location with the body
screws that were used to install the original 4 cylinder
mounts no modifications required. Engine side - the
mounts attach to the stock Chevrolet V8 clamshell motor
mounts that attach to the motor. This is not a Hurst or
TransDapt/Headman type setup, therefore these mounts will not work
with these hedders. The Don Hardy hedders went above
the mounts and behind along the floor boards ala the
Monza exhaust manifolds. I called Don Hardy to see if
they had Hedders available and they didn't. So I
removed this setup and went with the TransDapt elephant
ears on the front of the motor and Hedmans. Any
interest email me at
vega_man_larry@yahoo.com.

Thanks,
Larry


[This is message #299 by user vega_man_larry on Yahoo! Club HBOA Classified: http://clubs.yahoo.com/clubs/hboaclassified ]