From: denisst78_REMOVE_728046_THIS_@yahoo.com
Ben,
i think those adaptor are
really
inexpensive look how much they are selling
before making
one
for a side note
i think they don`t recomand using
those
adaptors whit a manual trans
because you`ll need to
place a spacer between the crank and the flywheel or
use a taller trowh out bearing(so the clutch won`t
over travel amd retain a good geometry)
and the
second problem is the pilot bearing
the input shaft
of the trans must be centered in the crank
maubee
you could make a spacer that will move your flywheel
a 1/4 inch out and machine the inside bore so it
will accept the pilot bearing or bushing
(use a
bearing for GM 6.2 Diesel it`s much better then a bronze
bushing)
Denis
[This is message #258 by user denisst78 on Yahoo! Club HBOA TECH CLUB: http://clubs.yahoo.com/clubs/hboatechclub ]