From: denisst78_REMOVE_545451_THIS_@yahoo.com
Use the spindel and brakes from a s-10 truck
(g-bodies also use the same spindels)
for the
upper ball joints:
weld shut the 2 rear mounting
holes,
use the boot retainer as a template and
redrill
the 2 rear holes
enlarge the large hole whit
a die grinder
for hte lower ball joint:
you can weld a new larger sleeve to accept the
s-10 ball joint or
buy some ball joint adaptors
that will adapt
monza ball joint to the s-10
spindels
Denis
[This is message #370 by user denisst78 on Yahoo! Club HBOA TECH CLUB: http://clubs.yahoo.com/clubs/hboatechclub ]