S10 Axle

[h-bot]

From: MoosiE4_REMOVE_382168_THIS_@yahoo.com


Can the entire pumkin of an S10 axle be put in a
Monza by transfering the tubes only but using all the
other parts from the S10? I need to know cause my 75
2+2 will find itself with a set of posi 4.11s if I
can make it work. I know anything is possible but is
it worth it?


[This is message #559 by user MoosiE4 on Yahoo! Club HBOA TECH CLUB: http://clubs.yahoo.com/clubs/hboatechclub ]

[h-bot]

From: denisst78_REMOVE_658841_THIS_@yahoo.com


a whole lot easier then that....
grab the
gears and posi unit of the
s-10

Install
the gear and posi using the bearings
that are
listed in theis club or the FAQ list
(look in the
old post on this club we try to
remove useless
post so it`s easy to find stuff)

You`ll need;
s-10 gears
s-10 posi unit (if it`s posi)
s-10
axels ( 2 wheel drive only)
if you reuse the monz
axels
check if the carrier of the
s-10 is a
26 splines unit)
S-10 rear end yoke
s-10
drums (if you use the s-10
axels)
an adaptor u
joint (listed here too)


Denis
This way
no welding or messing around


[This is message #560 by user denisst78 on Yahoo! Club HBOA TECH CLUB: http://clubs.yahoo.com/clubs/hboatechclub ]