From:
billy_b_85222_REMOVE_361034_THIS_@yahoo.com
With the tranny out of the car,and the converter
pulled out of the tranny it will take you all of 30
seconds to remove each seal.It is very simple to do.If
you need to replace the front pump oring stand the
tranny on end,remove the pump bolts and pry out the pump
with a couple of small screw drivers about 1/2
inch.Replace the large o-ring and slide the pump back into the
housing.Dont let any dirt get into the tranny when doing
this.Also plug the tailshaft with a used yoke to keep the
fluid in the tranny when you stand it on end.I used
bungy cord and lashed the tranny to my dolly so it
would stand up.Its not hard to do.The seals themselves
are so simple to replace you wont believe it.The 2
seals and the o-ring can be purchased at a local tranny
shop under 10 bucks.Good luck dude! Bill in Az...
[This is message #337 by user billy_b_85222 on Yahoo! Club Marco's Monza Messageboard:
http://clubs.yahoo.com/clubs/marcosmonzamessageboard ]