THM350 Dipstick ?

[h-bot]

From: nt664_REMOVE_551946_THIS_@yahoo.com


What are some options for a THM350 Tranny
dipstick? Mine came with a cobbled setup and I can't seem
to find anything that comes close to working. I
would like to find something cheaper than $56 for the
flexible Lokar setup. What is everyone else using?
Thanks.

Regards,
Elliot
1974 Vega Wagon


[This is message #307 by user nt664 on Yahoo! Club v8 hbody: http://clubs.yahoo.com/clubs/v8hbody ]

[h-bot]

From: denisst78_REMOVE_912107_THIS_@yahoo.com


first time i made a V-8 swap i used one for ma

1981 and down camaro,
if i remember right it
cleared well the firewall,
you might have to bent it
a bit but if you`re carefull you won`t kink
it

Denis


[This is message #309 by user denisst78 on Yahoo! Club v8 hbody: http://clubs.yahoo.com/clubs/v8hbody ]

[h-bot]

From: vegagt8_REMOVE_283377_THIS_@yahoo.com


I used a 74 Chevelle Dipstick, and bent it to fit with a tube bender.


[This is message #312 by user vegagt8 on Yahoo! Club v8 hbody: http://clubs.yahoo.com/clubs/v8hbody ]

[h-bot]

From: dracer327_REMOVE_735500_THIS_@yahoo.com


Cut the end of the tube (trans end) allow about 1-1/2" above the o-ring. Clamp heater hose to the tube. Correct length of hose to make the right length. This will allow the flexibility you need.


[This is message #322 by user dracer327 on Yahoo! Club v8 hbody: http://clubs.yahoo.com/clubs/v8hbody ]