Page 1 of 1

Headers and motor mounts (front style) SBC BBC

PostPosted: Fri Apr 27, 2007 3:08 pm
by Sirshredalot
Hooker:

Super competition full length headers. 265-400

2135HKR painted (1 1/2 primary tubes, 31" length tubes, 2 1/2 collector)
2135-1HKR Ceramic Coated

2129HKR Painted (1 3/4 primary, 31" tubes, 3" collector)
2129-1HKR Ceramic coated
(tubes outside fender/frame)

Super Competition full length headers 396-502

2240HKR Painted (2 1/8 Primary, 33" tubes, 3 1/2 collector)
2240-1HKR Ceramic Coated

MOTOR MOUNTS (front style) Small Block
1971-1974...12601HKR
1975-1980...12608HKR

MOTOR MOUNTS: Big Block
1971-1980...12603HKR

TRANS-DAPT...Motor mounts and Crossmember...Small Block
4686 (front style)

-Note: Motor mounts will fit both monza and vega chassis, but the transmission crosmember will not fit the monza chassis as the mounting pads in the earlier vega are narrower. Crossmember WILL fit vega chassis.

God bless
-Shred

Re: Headers and motor mounts (front style) SBC BBC

PostPosted: Tue Aug 03, 2010 4:06 pm
by 1972gt
how much is this setup

Re: Headers and motor mounts (front style) SBC BBC

PostPosted: Tue Aug 03, 2010 4:29 pm
by Sirshredalot
Havent checked recently, but you might take a peek at some online suppliers like Jegs.com or summitracing.com
Last I saw, www.Speedwaymotors.com had a deal going on the conversion kit...might check them out...I like them better than the previous two sites listed.

God bless
-Shred