Question on what tool to use. I removed the driveshaft to work on the rear end on my 76 Monza 7.5"
In the past I just tended to hand tighten the U-bolts on the U-joint caps as I can never get a torque wrench socket to fit in there. Is there such a tool that would look like half a 1/2" wrench that had a socket connection at one end so you can use a proper torque wrench on it? And what torque setting should it be? I have never worried about it before but too tight and you would crush the cap and screw up the needle bearings inside the cap.
Thanks