Page 1 of 1
Need Help Identifying Output Shaft
Posted:
Sat May 20, 2017 4:38 pmby hammerdown7
This main shaft has a 27 spline output, I have not been able to identify what transmission it is for. I was told a GM 5-speed but can't match it.
edit: This probably is an output shaft, not input, but I still have not been able to identify.
P1010660.jpg
Re: Need Help Identifying Main Shaft
Posted:
Tue May 23, 2017 7:04 pmby 75Monzta
It looks to be correct with the proper spots for (left to right) 4th, 5th, 2nd, 3rd, Rev and 1st.
Re: Need Help Identifying Main Shaft
Posted:
Tue May 23, 2017 10:28 pmby Smiley
maybe 2WD S10
Re: Need Help Identifying Main Shaft
Posted:
Wed May 24, 2017 7:11 amby hammerdown7
I have searched every transmission main shaft image I can find and haven't found one that looks like this one, quite a puzzle!
Dick
Re: Need Help Identifying Main Shaft
Posted:
Wed May 24, 2017 9:00 pmby 75Monzta
I just realized my post had almost 37.9% of the info missing that I wanted to post. I meant to say it almost looks like a T50 mainshaft and if you could take measurements from middle land right behind pilot to each gear surface, I could measure that against my T50 cluster gear I have.
Re: Need Help Identifying Main Shaft
Posted:
Wed May 24, 2017 9:28 pmby hammerdown7
I'll post dimensions tomorrow evening, that for checking.
Dick
Re: Need Help Identifying Main Shaft
Posted:
Wed May 24, 2017 11:37 pmby 75Monzta
No problem.
I also have a genuine GM T50 5th gear.
Re: Need Help Identifying Main Shaft
Posted:
Thu May 25, 2017 8:00 pmby hammerdown7
Even though it doesn't look like it the tape starts even with the end of the shaft.
P1010664.jpg
Re: Need Help Identifying Main Shaft
Posted:
Fri Dec 01, 2017 10:43 pmby hammerdown7
Although I still am not able to identify what trans this is for, my description is wrong. Since this shaft does not have a pilot bearing extension on the spline end it is more than likely to be an output shaft. Does that stir any ideas?
Dick