Page 1 of 1
75 h body w LS engine 4l60 driveshaft torq arm length ?
Posted:
Fri Jun 10, 2022 9:27 amby Bubbabigblokwingnut
Has anyone posted any information about the length of the driveshaft and torque arm being used in a Vega with a ls swap and 4l60 trans? It looks like the 4 cylinder torque arm is going to be too long . I was thinking that the 96 Camaro torque arm may be just right using it. My aluminum driveshaft measures 36 inches from weld to weld and the last 4 of the part numbers are 4004 from a fbody car. Any info will be appreciated
Re: 75 h body w LS engine 4l60 driveshaft torq arm length ?
Posted:
Sun Jun 12, 2022 10:27 pmby flathead52
Sorry I can’t answer your question, but did you get the 4l60 in without cutting the trans tunnel?
Re: 75 h body w LS engine 4l60 driveshaft torq arm length ?
Posted:
Mon Jun 13, 2022 10:33 pmby Smiley
Someone did use a later aluminum F body driveshaft, but there are a lot of variables that determine driveshaft length.
I have had to have mine shortened twice, once when upgrading the rear and from an 8 inch Ford to a GM 12 bolt and then again going from a TH350 to a late Muncie 4 speed which was 3/4” longer than the early Muncies.
Re: 75 h body w LS engine 4l60 driveshaft torq arm length ?
Posted:
Mon Aug 28, 2023 8:27 pmby Bubbabigblokwingnut
I did cut the trans tunnel out and fabricated it .