Moderator: Moderators
Bigdawg 72 wrote:Just was want to ask someone out there about the hooker headers #2311 hooker says to move back "4" inches,"4" inches from what staring point ?? Also are this header worth messing with for the street/strip? Thanks
mldeolde wrote:THE 4" is probably measured from the stock factory mounting position. i was able to move my engine back an 1 1/2 or so with my 2129's on my imsa but i can see no way to get 4" set back without torching the firewall and refabracation of it. good luck but you wiil have to cut!!!!!!!!!!!! IF YOU HAVE THE OPTION" read $$$$$$$$$$$" it would probably be much easier to go with a pair of 2129's .they have 1 7/8 tubes and a 3 1/2" collector and tho a bitch to install they are easier than what it will take to install yours. there are much easier sets available that bolt right in even with stock mounts and work quite well if you don't have to have the most killer set available for racing. for street use there are much better options.
L79racer wrote:I didnt know hooker made a 2311 race header. Where did you get it from and does it have to set the motor back like the stahl header??? I looked on summit and they dont list it.
Users browsing this forum: No registered users and 11 guests