From:
Phantom402_REMOVE_648657_THIS_@yahoo.com
most rearend shops know the widths of stock stuff
try moser he should have stock widths on file ,,,but
heck if you want it done right just measure the inside
width of wheel wells add 1 in to each side for cearance
1/2 in if your only going in straight line . then
measure to outside of wheel wells then measure the wheels
you are going to use then take measurement off of
back side(mounting surface to inside of tire(yardstick
across then use tapemeasure add your clearance(1 in or
1/2 in per side as you decide) and add that to inside
wheel well width (add both sides0 and bang you have
your width to fit YOUR CAR.
good luck email me at
Xanadu4024@aol.comLee
[This is message #426 by user Phantom402 on Yahoo! Club v8 hbody:
http://clubs.yahoo.com/clubs/v8hbody ]