I need some/alot of help identifying my harness and connections. We have a '77 Astre that we purchased with no engine and trans. We have everything installed except the engine harness and dash wiring. When we bought the car it came with harnesses that appeared to be factory. But after looking at the wiring diagrams that Spencer posted for a 77 Vega, I've discovered that ours is not the same.
Is the Astre wiring different than the Vega? If yes, then does anyone have a wiring schematic? If no, then I guess I'm in need of alot of help.
I checked through all of the diagrams on Spencer's post and none of the bulkhead arrangements match ours. The 1st thing I was checking was the oil pressure sensor as I intend to use an in tank fuel pump and I wanted to use the stock setup. But, when checking the wiring, I found that the three wires that supply the sensor are as follows when looking at the sensor plug from the sensor side : at the 9 o'clock position is the pink wire that runs to the iginition switch, at 12 o'clock is a blue wire that goes to bulkhead connector 'O', and at 3 o'clock is a black wire w/ a white stripe that goes to a seperate plug in the proximity of the bulkhead connector.
For some background, I believe that this harness was used with a V6 that someone installed prior to us purchasing the car. I am in the process of verifyig wiring on the inside bulkhead connector.
I could use a picture of the fuse panel with fuses labelled as ours is not very legible.
Any help is appreciated - thanks