by astre75 » Fri Nov 18, 2016 2:19 am
I had a race shop back in the 80s weld in some frame connectors on my 73 hatchback and the location of those were from just ahead of the lower rear control arm,,,,,, up to the pad where they locked the vegas in the rail cars for shipment,,,,the connectors were 2 by 2 square but they did hang down a bit,,,I have just made a set for my 1975 astre wagon that are 1 by 2 square so they will not hang down much,,and they are not so high that I have to cut the floor.I also think if you ran a bit of a rail up to the actual frame in the front would be a huge strength improvement,,,which is what I will probably do at the same time,,,got a friend with hoist and shop.