I'm just getting around to hooking up my rebuilt sending unit and new Carter pump. It's out of the gas tank and ready to bench test. When I hooked power up to the sending unit, the fuel guage pegged to full even though the float is hanging down in the empty positon. When I cranked the engine over while the pump was submerged in a pail of gas with a hose going to another pail, nothing, no pumping of gas or anything. There has been no changes to the wiring/eletrical except a new coil last fall.
I no not much about wiring electrics but can follow directions pretty well, what should I be looking for. My volt meter says power is going to the wires for the sender/pump. Help please.
Rick