This is a Custom build - Will probably never be another for us.
Had to have a donor rear first (customer supplied)for the control arm and pan hard spring perch brackets...
Used the CAmaro 82-2002 Camaro MOSER ENGINEERING rear with Ford large bearing ends (depending on the brakes being used you can choose from GM small or Large or any one of the many FORD housing ends out there... Just look at the Moser web site for Housing ends.
Torque arm bracket will still need to be modified from a Aftermarket Camaro torque arm. This was a Housing axle package deal, any width needed...
All parts were installed and supplied for the center section by J D Race
-Eaton Posi
- Ring and pinion
- Bearings and seals etc.
- Yoke...
Wilwood brakes (matched up with brake offset and housing ends calculates from the wheel well width needed and rims being used and their acquired offset.)
Plan to spend more than the car was purchased for in the 70's.
It was a FUN Build, But I do not see production of a unit like this anytime soon.
I was just lucky that someone trusted and had the wiliness to see it through...
J D