zeke's Monza

[zeke]

I don't think it's a problem, I think they just do something different on cylinder# 5 & 6 tubes. I should know soon.

[avewhtboy]

I don't think it's a problem, I think they just do something different on cylinder# 5 & 6 tubes. I should know soon.

I may not have been clear, I have Sandersons already and I was thinking about getting Vortec Heads. I don't want to have to buy headers again!

[zeke]

Looks like the above information could be erroneous.

Summit called Sanderson and spoke to Brandon who says the headers I ordered will work fine with Vortec heads. Apparently, Sam may be confused, I know I am.

[zeke]

Mass production run of two!

[zeke]

Just needs the mosfets and regulators. I found it easier to mount all four devices onto the heatsink first, on the prototype. 

[zeke]

Still waiting for exhaust system components.

[zeke]

Made a jig for milling out the cover from a piece of retired computer case steel.

[zeke]

This should make installing the connector easy.

[zeke]

About an hour to wire the switch and connector, each. After testing, I will insulate the exposed connections.

[zeke]

So I ordered CC13 and got CC13AP with the CC11AP passenger side header. Clear as mud. Hope I can make them fit.

[spencerforhire]

If you can get those Sandersons to fit without the use of a BFH or the "blue tipped hot wrench", I will sell my Hooker 2135's in a flash.

[6D9]

Looking good!

[zeke]

If you can get those Sandersons to fit without the use of a BFH or the "blue tipped hot wrench", I will sell my Hooker 2135's in a flash.

No hammer, no torch - check!

Making new engine mounts also so I will be able to set the height to whatever works. Hopefully won't need to modify the air cleaner - again.

Thanx 6D9

[zeke]

Made a new visor decal. Just printed on paper to see how it looks. Will be getting stickers made.

[spencerforhire]

That decal looks great, but it brings you uncomfortably close to the "purist" category of H-body owner. Like Bob.