1972 Chevy Vega
Bought this car, was an ex drag car. 90% of the wiring is still there, just the whole car was gutted. There are some cut wires, I have repaired some, a couple lead to no where, as in, can't find the other end, others the wires are cut right at the "connector block".
Problem are as followed:
- The turn signal switch does not work. The hazards switch does work.
- I have no dash lights, as in the backlighting, the turn signals (with the hazards) work, and the blue light for high beams works too.
I have replaced the turn signal switch. The hazards work. The running lights/headlights/brake lights all work.
Is there a separate flasher relay for the turn signals? If so, can anyone take a picture of the connector and wires.
Is there a common ground for the dash? If so, where?
Also, this may be a dumb question. But the wiper blade button. How do you operate it? It has a "Push" button, and a slide. I see you can slide the slide switch in three positions. I presume Off, Low, and High for wiper speeds. Then the push button. I push that in and it stays in, and moves the slide button to the Low position. But now I cannot move the slide back to the off position. Well I can, but I have to grab the push button with a pair of pliers and pull it out, then move the slide to the Off posistion. Obviously this is incorrect operation, but wondering if I'm just being dumb, or if my switch is broken.