Thanks for the feed back on this subject,as now I am sure about one thing it matches the hole on the other car.,,, But here is another question
my son in law reached thru the cowl hole ventaltion in the right hand side kick panel body hole to pull the antenae down in to the car interior temporarlaly to see if this was the way to run the antenae lead and what was funny to me was he stuck his fingers thru the side of the fender under the hood next to the blower motor.,,,,, a new discovery a light bulb went off and I thought if his hand was showng then may be a cover of metal and/or insulation stuffed into the between the inner body panel and the outer fender "void" near where his fingers exited,, would effect the air flow from the under hood heat into the interior comparment
and thanks to AUS I will rethink the hole in the inner fender panel and see if there is another way to route the hole for the cable lead ???Anybody else got any ideals
I know that when you run an antenae in to almost any wall you need a low kink in the lead blow the botom of the hole to make rainwater or other H20 drip below and not into the interior.,,,,, thank you for yours and everybody's opion. Mike