Bell housing hole.. Grommet cable question

[1ton454]

I have the iron duke vega bell housing #360162 i plan on using with saginaw 4 speed and SBC in a 72 Vega.. My question is is there a grommet for the hole where the cable comes through the bell housing or is this built into the cable itself ? Also anyone have a part number for clutch cable i need for my application ? Help much appreciated thanks

[Sunbird John]

Are you talking about the rubber grommet in the tin cover?

[1ton454]

I dont have the tin cover I need one those actually. I am talking about the hole on that flange upper right of bellhousing im assuming where clurch cable passes through

[cjbiagi]

The upper right corner of the bellhousing is where the ballstud pivot is for the clutch fork. The cable enters on the bottom left corner. I have a brand new clutch cable for a early Vega with the pulley under the dash. This is correct for a 4 cylinder application, what engine do you have? This cable measures 54" tip to tip. Here is a pic of the bellhousing and the tin cover, I do have new grommets for the tin cover, there is no grommet where the cable enters. Ooops, I see you have a SBC so you need the longer cable. I can get one for you, I have extra's for my car.
cjbiagi@yahoo.com

[cjbiagi]

Here is a pic of the grommet, I assume you still have the pulley for the clutch cable under the dash?

[1ton454]

Where does this grommet go ?

[cjbiagi]

It goes on the tin cover where the return spring passes through. Look at the pictures above and you can see it.